Proson RV2040 Bedienungsanleitung PDF herunterladen (Seite 8)

FIRST THINGS FIRST

CONNECTING THE SPEAKERS

CONNECTING THE WIRES

CONNECTING THE MAIN SPEAKERS

The two main speakers should be set between six and 10 feet apart. Putting the speakers any closer or

any farther apart may result in distorted sound.

The speakers should also form a 45 degree angle to the central listening point in the room, creating a

triangle of listening enjoyment.

CONNECTING THE ANTENNAS

The AM and FM antennas connect to the AM and FM

terminals on the system's back panel. They must

be hooked up for you to receive clear reception.

Uncoil the antenna wires and locate the bare ends.

Press down on the tab to open the terminal and

insert the wire. Snap the tab closed.

After connecting the antennas, extend them to

their full length and adjust their positioning for

better reception.

Method 1

Method 2

1.Loosen the knob.2.Insert the bare wire.[Remove

approx.5mm(1/4 ) insulation from the speaker

wires]. 3.Tighten the knob and secure the wire.

Or you also may use banana plug.

Speaker Polarity

When connecting the speakers, make sure the

polarities("+" speaker wire to "+" on the receiver)

of speaker wires and terminals are matched.

If the cords are reversed, the sound will be distort-

ed and will lack bass("out of phase"effect).

NOTE:

Do not let the bare speaker wires touch each

other or any metal part of this unit. This could

damage this unit or the speakers, or both.

Connect the speakers terminals to your speak-

ers with the wire of the proper gauge

(keep as short as possible).if the connections are

faulty,no sound will be heard from the speakers.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Keine Kommentare

Proson RV2040 Bedienungsanleitung Seite 8